Tracking, Erosion and Morphological Study of Heat Shrink Anti Tracking Tubes


Moumita Naskar
K. P. Meena


Components of Medium Voltage (MV) cable network are very much vulnerable under operational stresses and ageing. Heat Shrinkable Anti-Tracking Tube (HSATT), an integral part of the Joints and terminations of the MV cable network system is used to cover and safeguard the power cable joints. In cable system joint and termination are the weakest but the critical part and fail easily under stress. The most threatening source of HSATT failure is electrical tracking. Electrical tracking develops when a conducting path across the HSATT formed under electric stress due to surface discharge. Arcs created from this surface discharge phenomenon burn the HSATT and create carbonized tracks in the long run. This paper reports the electrical tracking performance of three commercially available HSATT samples. Crosslinked polyethylene (XLPE) is the key ingredient for heat shrinkable materials. Electrical tracking using the inclined-plane tracking (IPT) method develops from surface discharge activity followed by erosion under wet and contaminated conditions. So, the material under IPT test faced electrical, environmental and thermal stresses. Among these three HSATT samples two samples failed to withstand these three dimensional stress factors. Dielectric breakdown strength and volume resistance tests were carried out to cross examine the IPT results and the results are identical. The morphology has been studied to understand the failure mechanism of HSATT samples. A morphological model is presented to scrutinize the IPT test failure mechanism and the rate of erosion propagation in the HSATT samples.


How to Cite
Naskar , M. ., & Meena, K. P. . (2022). Tracking, Erosion and Morphological Study of Heat Shrink Anti Tracking Tubes. Power Research - A Journal of CPRI, 18(1), 19–23.


  1. Hoffman JE. Insulation enhancement with heat-shrinkable components. IEEE Electrical Insulation Magazine. 1991; 7(2):33-8. DOI:
  2. Kumagai S, Yoshimura N. Tracking and erosion of HTV silicone rubber and suppression mechanism of ATH. IEEE Trans Dielectr Electr Insul. 2011; 8:203-11. https://doi. org/10.1109/94.919930 DOI:
  3. Piah MAM, Darus A. Electrical tracking performance of LLDPE- Natural rubber blends by employing combination of leakage current level and rate of carbon track propagation. IEEE Trans Dielectr Electr Insul. 2005; 12(6):1259-65. DOI:
  4. Wang X, He HQ, Tu DM, Lei C, Du QG. Dielectric properties and crystalline morphology of low density polyethylene blended with metallocene catalyzed polyethylene. IEEE Trans Dielectr Electr Insul. 2008; 15(2):319-26. https://doi. org/10.1109/TDEI.2008.4483448 DOI:

Most read articles by the same author(s)