Voltage Sag Mitigation in a Three-Phase Induction Motor using DSTATCOM and DVR

##plugins.themes.academic_pro.article.sidebar##

Published Sep 30, 2012
Download
PDF
Statistic

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...
Volume 8, Issue 3, September 2012

##plugins.themes.academic_pro.article.main##

B. V. Ramprasad
SVNIT, Surat
Khyati Mistry
Asst. Professor, Department of Electrical Engineering, SVNIT, Surat, Gujarat

Abstract

Voltage sag in distribution system is one of the most frequently occurring power quality problem, There are many solutions to mitigate voltage sag. This paper describes one such technique to mitigate voltage sag occurring during the starting of three-phase induction motor by using power electronic devices called Dynamic Voltage Restorer (DVR) and Distribution Static Compensator (DSTATCOM). This paper is organized with a brief introduction of voltage sag and its characteristics, structure and control principles of DSTATCOM and DVR. The performance of both DSTATCOM and DVR to mitigate voltage sag caused by starting of three phase induction motor is observed and compared. The simulation models of both the devices are analyzed and results are shown.

##plugins.themes.academic_pro.article.details##

How to Cite
Ramprasad, B. V., & Mistry, K. (2012). Voltage Sag Mitigation in a Three-Phase Induction Motor using DSTATCOM and DVR. Power Research - A Journal of CPRI, 163–170. Retrieved from https://cprijournal.in/index.php/pr/article/view/379

References

  1. Sannino A and Svensson J. “Application of converterbased series device for voltage sag mitigation to induction motor load”, Power Tech Proceedings, IEEE, Porto, Vol. 2, 2001.
  2. Devaraju T, Veera Reddy V C and Vijay Kumar M. “Modeling and simulation of custom power devices to mitigate power quality problems”, International Journal of Engineering Science and Technology, Vol. 2, No. 6, pp. 1880–1885, 2010.
  3. Huweg A F, Basi S N and Mariun N. “A STATCOM simulation model to improve voltage sag due to starting of high power induction motor”, National Power and Energy Conference (PECon), Kuala Lumpur, Malaysia, pp. 148–152, 2004.
  4. Anaya-Lara Olimpo, Acha E. “Modeling and analysis of custom power systems by PSCAD/EMTDC”, IEEE, Transactions on Power Delivery, Vol. 17, No. 1, pp. 266–272, January 2002.
  5. Mohammadi M. and Akbari Nasab M. “Voltage sag mitigation with DSTATCOM in distribution systems”, Australian Journal of Basic and Applied Sciences, ISSN 1991-8178, pp. 201–207, 2011.
  6. Huweg A F, Bashi Mieee S M and Mariun Smieee N. “Application of inverter based shunt device for voltage sag mitigation dueto starting of an induction motor load”, CIRED, 18th International Conference on Electricity Distribution Turin, 2005.
  7. Ajay K. Damor, and Babaria V B. “Voltage sag control using DVR”, National Conference on Recent Trends in Engineering and Technology.
  8. Pierre Giroux, Gilbert Sybille, Hoang LeHuy.s “Modeling and Simulation of a Distribution STATCOM using Simulink’s Power System Blockset”, IECON, 01: the 27th Annual Conference of the IEEE, Industrial Electronics Society, pp. 990–994.