Fuel and Cost Optimization of Grid-Connected MTG-PV-Based Hybrid System

##plugins.themes.academic_pro.article.main##

Grishma J. Patel
Shabbir S. Bohra

Abstract

An MTG-PV hybrid system is a reliable DG-based system because PV is unpredictable non-traditional energy source whereas Mictroturbine is a controllable traditional energy source, which will cancel out each other’s drawbacks. In this paper, a microturbine generation system (MTG) is considered as the backup generation to meet the energy requirements when solar energy is not suffi cient. Main objective of this paper is optimization of Fuel and Cost of grid-connected MTG-PV hybrid system. Analysis of power management and fuel optimization is carried out using the MATLAB/SIMULINK platform. HOMER (Hybrid Optimization Models for Energy Resources) power optimization software by NREL (National Renewable Energy Laboratory) is used to optimize the cost of the hybrid system.

##plugins.themes.academic_pro.article.details##

How to Cite
Patel, G. J., & Bohra, S. S. (2012). Fuel and Cost Optimization of Grid-Connected MTG-PV-Based Hybrid System. Power Research - A Journal of CPRI, 143–152. Retrieved from https://cprijournal.in/index.php/pr/article/view/377

References

  1. Grishma J Patel and Shabbir S Bohra. “Modeling and analysis of MTG based isolated and grid connected system”, 2nd International Conference on Current Trends In Technology,“Nuicone–2011” IEEE, at Institute of Technology, Nirma University, Ahmedabad 382 481, 08–10 Dec, 2011.
  2. Gaonkar D N and Patel R N. “Dynamic model of microturbine generation system for grid connected/islanding operation”, Industrial Technology, ICIT 2006. IEEE, International Conference, Mumbai, India, pp. 305–310, December 2006.
  3. Guda S R, Wang C and Nehrir M H. “Modeling of microturbine power generation systems”, Electrical Power System and Components, Vol. 34, No. 9, pp. 1027–1041, 2004.
  4. Ashwanikumar, Jain S P, Sandhu K S, and Sharath kumar P. “New converter controller model for modeling of microturbine based distributed generation system”, 2nd WSEAS/IASME International Conference on renewable energy sources (RES’08), Greece, October 26–28, 2008.
  5. Walker G. “Evaluating MPPT converter topologies using a MATLAB PV model,” Journal of Electrical and Electronics Engineering, Australia, IEEE, Vol. 21, No. 1, pp. 49–56, 2001.
  6. Chouder A, Silvestre S, and Malek A. “Simulation of photovoltaic grid connected inverter in case of grid-failure”, Revue des Energies Renouvelables, Vol. 9, No. 4, pp. 285–296, 2006.
  7. Dave Freeman. “Introduction to Photovoltaic Systems Maximum Power Point Tracking”, Texas Instruments Incorporated, Application Report SLVA446, November 2010.
  8. Femia N, Petrone G, Spagnuolo G, Vitelli M, “Optimizing sampling rate of P and O MPPT technique”, in Proc. IEEE, PESC, pp. 1945–1949, 2004.
  9. Nehrir M H, Wang C, Strunz K, Aki H, Ramakumar R, Bing J, Miao Z, and Salameh Z. “A review of hybrid renewable/ alternative energy systems for electric power generation: configurations, control, and applications”, IEEE, Transactions On Sustain Able Energy, Vol. 2, No. 4, pp. 392–403, October 2011.
  10. United States (US) National Renewable Energy Laboratory’s (NREL) HOMER Software. https://analysis.nrel.gov/homer.
  11. “HOMER Energy” [Online], Available at: http://www.homerenergy.com/
  12. Lau K Y, Yousof M F M, Arshad S N M, Anwari M, and Yatim A H M. “Performance analysis of hybrid photovoltaic/diesel energy system under Malaysian conditions”, Energy 35, 7 April 2010.
  13. Solar system equipment prices, Sun electronics, http://sunelec.com.
  14. NASA surface meteorology and solar energy, http://eosweb.larc.nasa.gov.
  15. Microturbine system equipment prices, capstone turbine, http://capstoneturbine.com.
  16. Lambert T, Gilman P and Lilienthal P. “Micropower system modeling with HOMER”, Integration of Alternative Sources of Energy, Farret FA, Simões MG, John Wiley & Sons, December 2005.
  17. Shafi ullah G M, Amanullah M T, Oo, ABM Shawkat Ali, Dennis Jarvis, Peter Wolfs. “Economic analysis of hybrid renewable model for subtropical climate”, Int. J. of Thermal and Environmental Engineering, Vol. 1, No. 2, pp. 57–65, 2010.